TV Typewriters
Appendix A
Some AI Koans
A Story About `Magic'
Some years ago, I (GLS) was snooping around in the cabinets that housed the MIT
AI Lab's PDP-10, and noticed a little switch glued to the frame of one cabinet.
It was obviously a homebrew job, added by one of the lab's hardware hackers (no
one knows who).
You don't touch an unknown switch on a computer without knowing what
it does, because you might crash the computer. The switch was labeled
in a most unhelpful way. It had two positions, and scrawled in pencil
on the metal switch body were the words `magic' and `more magic'.
The switch was in the `more magic' position.
I called another hacker over to look at it. He had never seen the
switch before either. Closer examination revealed that the switch
had only one wire running to it! The other end of the wire did
disappear into the maze of wires inside the computer, but it's a basic
fact of electricity that a switch can't do anything unless there are
two wires connected to it. This switch had a wire connected on one
side and no wire on its other side.
It was clear that this switch was someone's idea of a silly joke.
Convinced by our reasoning that the switch was inoperative, we flipped
it. The computer instantly crashed.
Imagine our utter astonishment. We wrote it off as coincidence, but
nevertheless restored the switch to the `more magic' position before
reviving the computer.
A year later, I told this story to yet another hacker, David Moon as I
recall. He clearly doubted my sanity, or suspected me of a
supernatural belief in the power of this switch, or perhaps thought I
was fooling him with a bogus saga. To prove it to him, I showed him
the very switch, still glued to the cabinet frame with only one wire
connected to it, still in the `more magic' position. We scrutinized
the switch and its lone connection, and found that the other end of
the wire, though connected to the computer wiring, was connected to a
ground pin. That clearly made the switch doubly useless: not only was
it electrically nonoperative, but it was connected to a place that
couldn't affect anything anyway. So we flipped the switch.
The computer promptly crashed.
This time we ran for Richard Greenblatt, a long-time MIT hacker, who
was close at hand. He had never noticed the switch before, either.
He inspected it, concluded it was useless, got some diagonal cutters
and diked it out. We then revived the computer and it has run fine
ever since.
We still don't know how the switch crashed the machine. There is a
theory that some circuit near the ground pin was marginal, and
flipping the switch changed the electrical capacitance enough to upset
the circuit as millionth-of-a-second pulses went through it. But
we'll never know for sure; all we can really say is that the switch
was magic.
I still have that switch in my basement. Maybe I'm silly, but I
usually keep it set on `more magic'.
1994: Another explanation of this story has since been offered. Note that
the switch body was metal. Suppose that the non-connected side of the
switch was connected to the switch body (usually the body is connected
to a separate earth lug, but there are exceptions). The body is
connected to the computer case, which is, presumably, grounded. Now
the circuit ground within the machine isn't necessarily at the same
potential as the case ground, so flipping the switch connected the
circuit ground to the case ground, causing a voltage drop/jump which
reset the machine. This was probably discovered by someone who found
out the hard way that there was a potential difference between the
two, and who then wired in the switch as a joke.
--The Jargon File version 4.3.1, ed. ESR, autonoded by rescdsk.